Overview

Connect and fill

Remove the hose (1) from the storage compartment.

Open the protector's clamping valve (2).

Connect the FLOWBAG (A) to the hose (3) and blow air into the FLOWBAG (A) with your mouth from a distance of about 20 cm until it is full. Close the inlet opening and push the air into the protector. Repeat this process two or three times. When the protector is sufficiently inflated, you will clearly feel the increase in pressure and resistance.

Close the clamp valve (4) with four clicks and disconnect the FLOWBAG (A).

Secure the hose (5) using the magnets (6).

Alternative inflation methods

With the optional electric pump. The electric pump can also be used to deflate the protector.

Video Tutorial inflating the protector

InfoWe recommend using the FLOWBAG or the optional electric pump. The electric pump can also be used to deflate the protector. You can also inflate the protector by mouth. However, breathing air contains moisture and can promote mold growth.

WarningThe protector is sufficiently inflated when you feel a noticeable increase in pressure during inflation. Overinflation can reduce seating comfort.

WarningSharp objects such as walking poles etc. can damage the protector.

WarningDo not sit on the protector before the launch.

AchtungThe protector is approved, and full protection achieved, only if the above requirements are fulfilled.

Product manual

Contents