General

The release handle used with the five-flap inner container is part of the harness and complies with the latest certification requirements according to NfL.

WarningOnly use the original reserve handle and its attached inner container.

Packing the reserve parachute in the inner container

Always pack your reserve parachute to fit the shape and size of the supplied STRAPLESS BI 3 inner container. Place the rescue lines like shown in the picture. When all lines are stowed, there should be about 90 cm of line length left to the bridle.

WarningIf your reserve parachute does not fit in the inner container without excessive squeezing, this indicates that it is too big for the WEIGHTLESS.

Close inner container

Close the five-flap inner container in the order of the numbers on each flap 1-3. Secure the last flap 3 with a line loop that should be about 5 to 6 cm long (about 3 fingers wide). Now check the pull of the elastic and shorten or lengthen it as needed.

InfoThe line loop should release under the weight of the reserve parachute itself.

Close the last flap of the container with two line loops of equal length (5 to 6 cm). These final loops are held by two elastics that pass through the eyelets of the outer flap of the container. The two elastics are pre-assembled at the factory.

Paraglider models of other brands

Winching

Acro

Tandem flying