Easy attachment

First, the accelerator must be completely removed, then the protector is attached to the STRAPLESS 4 by six connection points:

(A) Bullet-Toggles at the legpads (left & right)
(B) Bullet-Toggles in the thigh area (left & right)
(C) Bullet-Toggles in the lower back area (left & right)

Guide the low-friction rings in the thigh area through the slots provided in the protector (D), before rethreading the accelerator. This is the only way to ensure that the accelerator runs correctly along the outside of the protector. (E)

Video Tutorial attaching the protector

Connect and fill

Open the protector's clamping valve. (1)
Connect the FLOWBAG (A) to the tube. (2)
Use your mouth to blow air into the FLOWBAG from a distance of about 20 cm until it is full. Close the opening and press the air into the protector. Repeat this process two to three times. When the protector is inflated properly, you will clearly feel the increase in pressure and resistance.
Close the clamping valve and disconnect the FLOWBAG. (3)
Stow the tube away. (4)

Video Tutorial inflating the protector

InfoWe recommend using the FLOWBAG supplied to inflate the protector. Alternatively, you can also inflate the protector by mouth. However, breathing air contains moisture and can promote mold growth.

WarningMake sure that the protector is sufficiently inflated before launching. You will clearly feel the increase in pressure and resistance when the protector is correctly inflated.

WarningSharp objects such as walking poles etc. can damage the protector.

WarningDo not sit on the protector before the launch.

AchtungThe protector is approved, and full protection achieved, only if one of the above requirements is fulfilled.

Features